Scotch Gel With Applicator Super Glue - .14 Oz
Loading..
Contains: Ethyl Cyanoacrylate, Hydroquinone.
Super Glue, Precision Applicator

No run gel. Patented no-clog dispenser. Bonds to: wood, metal, plastic (Not suitable for polystyrene foam, foam rubber, polyethylene and polypropylene.), ceramic and more! Less mess! (than metal-tube Super Glue gels). Stays fresh! Scotch Super Glue Gel in Precision Applicator features patented adhesive control technology for precision dispensing. The unique applicator allows you to dispense a controlled amount of super glue gel, without the oozing of traditional super glue gel in metal tubes. The clog-resistant stay fresh bottle avoids dry-out, so you can use the bottle over and over again. Convenient no-run gel is great for use on wood, metal, ceramic, leather, rubber, vinyl, plastic (Not suitable for polystyrene foam, foam rubber, polyethylene and polypropylene.), ceramic and more! Conforms to ASTM D-4236. For additional health and safety information, see Material Safety Data Sheet (27-8285-2) or call, 1-800-3M-HELPS. www.ScotchBrand.com. Made in Taiwan for 3M.

More

Product Attributes
Warning Contains: Combustible. Bonds skin and eyes instantly. Causes eye and skin irritation. May cause allergic skin reaction. may cause nose and throat irritation. Skin contact through clothing may cause burns. Precautions: Keep away from heat and flame. Avoid eye and skin contact. Do not get on skin or clothing. Avoid breathing of vapors. Use only with adequate ventilation. Do not swallow. Wash thoroughly after handling. Avoid excessive use of force to free bonded area. Close container after each use. Keep out of reach of children. Suggested First Aid: Eye Contact: Do not force eyelids open. Immediately flush eyes with large amounts of water for at least 15 minutes. Get immediate medical attention. Skin Contact: Wash affected area with soap and water. If signs/symptoms develop, get medical attention. For Skin Bonds: Quickly soak in warm water and avoid use of excessive force to free bonded area. If una
Directions 1. Clean surfaces and thoroughly dry. 2. Point tip away from face and body. 3. Do not squeeze dispenser buttons while puncturing. 4. To puncture turn nozzle and cap assembly down clockwise until fully seated and tight. 5. Remove cap by turning counterclockwise. 6. apply adhesive lightly to one surface only. 7. Firmly press parts together. Hold until set. 8. Wipe off excess immediately with paper towel. 9. Wipe applicator tip with cloth or tissue after use. 10. Replace cap. Screw on tightly. 11. Store with tip up in a cool, dry place. Keep back card for product directions.
About the Producer 3M
Disclaimer

Product details/images for convenience only.  Consult Product label for the most current and accurate information.  We assume no liability for any inaccuracies/misstatements about Products listed on our website/app.